';
side-area-logo

RAPID

RAPID DRYING FLOOR PAINT PW74
pw74-rapid

A single pack polyurethane coating and finish for internal use, for concrete, wood or steel floors.

  • Tough, hard-wearing flexible film.
  • Quick drying.
  • Can be used clear as a floor sealer.
  • Suitable for forklift traffic after 48 hours. Recoat in 8 hours and cures as low as -5°C.

SUITABLE FOR:
Concrete, wooden, steel floors, clean, free of contamination dust, efflorescence, dry & suitably prepared. Interior use only.

APPLICATION:
Brush & Roller

SHEEN LEVEL:
Gloss

COVERAGE:
10m2 per Litre

TOUCH DRY:
2 Hours

RECOAT:
8 Hrs Min. 16 Hrs Max

AVAILIBITY:
5 Litre

POT LIFE:
N/A

ADDITIONAL INFO:
Max recoat: 16 hours, Thinner: TP33

*At 60 microns DFT (loss factors will apply in practice)

Light Grey, Cardinal Red & Clear.

BS & RAL.

Correct preparation is vital to ensure you obtain the full benefit from Bradite Metal Paints.

New and unpainted steel

  • High pressure water cleaning to remove all loose salts and other contaminants.
  • Degrease using BRADITE TD39, with scrubbing plus high pressure water cleaning to remove any oil contamination not removed by high pressure cleaning alone, rinse with clean water and allow to dry.
  • Mechanically or manually prepared steel to a clean metallic finish, SIS-St 3 minimum.
  • Substrate to be dry, clean and free of contamination and dust free prior to coating.

Existing coatings

  • Jet wash to remove all loose and flaking paint, salts and other contaminants.
  • Degrease using Bradite TD39 diluted with up to 9 parts of warm water and scrubbing to remove any oil contamination not removed with jet washing alone. Rinse with clean water and allow to dry.
  • Existing coatings should be well adhered with all edges tight and well feathered.
  • Bare or rusted steel should be manually or mechanically abraded to a clean metallic finish (SIS-St 3).
  • Substrate should be clean, dust free and dry before application.
  • Spot prime with correct primer.
  • Galvanised steel, aluminium and other non-ferrous metals should be roughened or lightly abraded.
  • New bright galvanised steel should be degreased and treated with Bradite TM38 pre-treatment for galvanised steel.
ALTERNATIVE PRODUCTS

CLADIT

CLADDING FINISH WC44
just5lcladit-copy

CLADIT

CLADDING FINISH WC44
just5lcladit-copy

CLADIT

CLADDING FINISH WC44
just5lcladit-copy

CLADIT

CLADDING FINISH WC44
just5lcladit-copy